Set one straightened paper clip aside, you will use it at the
end. Bend the two tips of one of the two paper clips as shown.
Put it in through the fuse clip like this, but make sure the
notch in the fuse clip is facing out. (The clip has one edge bent inwards. This
is the part that has to face outwards). Study this next picture closely.
From the position above, bend the paper clip up and then
around the lead of the fuse clip as in the next picture.
Bend the paper clip under the fuse clip...
then up and over the fuse clip:
then around its other lead and you're almost done with the
first fuse clip.
First clip -- wire is on the RIGHT side of the fuse clip
leads...
Second Clip -- wire is on the LEFT side of the fuse clip
leads... But remember to make sure the notch in the fuse clip is facing out.
(The clip has one edge bent inwards. This is the part that has to face
outwards).
Follow all the steps above with the second clip and you get
this:
It's practically impossible to solder the FLEDs straight
using only your hands
This part is rather tricky because there's so little space between the Solar Engine and the 3300uF Cap. -- You can leave more space here if you like, but it just looks better if you keep it all nice and tight
Find two FLEDs with the same (or very similar) resistance