Group items tagged

How do I program my in-car transmitter to an Genie Intellicode or Chamberlain Security Plus system? Homelink in-car programming instructions: To program a built-in-car transmitter to a rolling code garage door opener (Genie rolling code is called Intellicode, Liftmaster/Sears is called Security plus), you should take the following steps. Clear out anything previously programmed into the in-car system from the factory by holding down on the 2-outside buttons simultaneously, until the in-car red light starts flashing rapidly.  This may take up to a minute.  (In a few cases, some make cars require the keys to be in the ignition, or the car motor must be running, or the car door must be shut) Decide which button you want to make to be your in-car garage door transmitter.  Hold your transmitter up near the selected button, pressing both the garage door remote and the selected in-car transmitter button simultaneously.  Hold down on the buttons until the in-car, red light flashes rapidly.  this sets the in-car transmitter to be your garage door openers make transmitter, but you are not done.  You now need to make this in-car transmitter your personal transmitter. Go to the Learn Button on your garage door opener.  The button is usually right next to the area the floppy antenna is connected to the motor head.  With Genie it is most often behind the light lens, and flashes red when pressed.  With Sears or Liftmaster (Chamberlain) it is near, or part of, the terminal screw board.  Press this learn button momentarily.  A red light should start to flash or an amber light should turn on and stay lit.  Go back to the in-car transmitter button you programmed and press this button 3 or 4 times, or until the door starts moving.  This should set your in-car transmitter to your garage door opener. How do I program my Intellicode or Security Plus Transmitter? The code changes every single time you press the button.  It is a rolling code transmitter and there are 4.5 billion combinations, so it is never on the same frequency twice!  If you've lost a transmitter you can delete out all of the transmitters programmed into you garage door opener by holdingdown on the learn button, or smart button until the light stops blinking.  The learn, or smart button is behind the light lens or on the back of the motor head and is close to the floppy antenna wire.  Some models require you to unscrew 2 bolts on the light lens to be able to remove the lens and access the learn button.  The smart button for Chamberlain openers is usually on the terminal board. To reprogram each transmitter, push the learn button momentarily and the red or amber light will start  blinking.  It will blink for up to 30 seconds.  In that time press one of your transmitters 3 or 4 times  until the garage door starts moving.  Keep the transmitter at least 2 feet away from the antenna.Perform the same process with each transmitter. If you are in need of an Intellicode transmitter (GIT-1), you can find them on our Web site in the Genie section.  If you need a Chamberlain (Liftmaster/Sears) Security Plus transmitter, go to the garage door transmitter section of our Chamberlain store.  Stanley and Linear have similar, rolling code transmitters.  To access our transmitters go to Transmitters and Receivers and click onto the appropriate manufacturer.