Group items tagged

Duke University engineer Nico Hotz has proposed a hybrid solar system in which sunlight heats a combination of water and methanol in a maze of tubes on a rooftop to produce hydrogen. The device is a series of copper tubes coated with a thin layer of aluminum and aluminum oxide and partly filled with catalytic nanoparticles. A combination of water and methanol flows through the tubes, which are sealed in a vacuum. Once the evaporated liquid achieves higher temperatures, tiny amounts of a catalyst are added, which produces hydrogen. This combination of high temperature and added catalysts produces hydrogen very efficiently, Hotz said. The resulting hydrogen can then be immediately directed to a fuel cell to provide electricity to a building during the day, or compressed and stored in a tank to provide power later. After two catalytic reactions, the system produced hydrogen much more efficiently than current technology without significant impurities, Hotz said. The resulting hydrogen can be stored and used on demand in fuel cells. "This set-up allows up to 95 percent of the sunlight to be absorbed with very little being lost as heat to the surroundings," he said. "This is crucial because it permits us to achieve temperatures of well over 200 degrees Celsius within the tubes. By comparison, a standard solar collector can only heat water between 60 and 70 degrees Celsius." Holtz performed a cost analysis, comparing a standard photovoltaic cell, a photocatalytic system, and the hybrid solar-methanol system.  He found that the hybrid system is the least expensive solution, with a total installation cost of $7,900 if designed to fulfill the requirements in summer. The paper describing the results of Hotz's analysis was named the top paper during the ASME Energy Sustainability Fuel Cell 2011 conference in Washington, D.C. Topics: Energy | Nanotech/Materials Science

The supply of secure, clean, sustainable energy is arguably the most important scientific and technical challenge facing humanity in the 21st century. Rising living standards of a growing world population will cause global energy consumption to double by mid-century and triple by the end of the century. Even in light of unprecedented conservation, the additional energy needed is simply not attainable from long discussed sources these include nuclear, biomass, wind, geothermal and hydroelectric. The global appetite for energy is simply too much. Petroleum-based fuel sources (i.e., coal, oil and gas) could be increased. However, deleterious consequences resulting from external drivers of economy, the environment, and global security dictate that this energy need be met by renewable and sustainable sources. The dramatic increase in global energy need is driven by 3 billion low-energy users in the non-legacy world and by 3 billion people yet to inhabit the planet over the next half century. The capture and storage of solar energy at the individual level personalized solar energy drives inextricably towards the heart of this energy challenge by addressing the triumvirate of secure, carbon neutral and plentiful energy. This talk will place the scale of the global energy issue in perspective and then discuss how personalized energy (especially for the non-legacy world) can provide a path to a solution to the global energy challenge. Daniel G. Nocera is the Henry Dreyfus Professor of Energy at the Massachusetts Institute of Technology, Director of the Solar Revolutions Project and Director of the Eni Solar Frontiers Center at MIT. His group pioneered studies of the basic mechanisms of energy conversion in biology and chemistry. He has recently accomplished a solar fuels process that captures many of the elements of photosynthesis outside of the leaf. This discovery sets the stage for a storage mechanism for the large scale, distributed, deployment of solar energy. He has b

Despite shifting into higher gear within the consumer's green conscience, hybrid vehicles are still tethered to the gas pump via a fuel-thirsty 100-year-old invention: the internal combustion engine. However, researchers at Michigan State University have built a prototype gasoline engine that requires no transmission, crankshaft, pistons, valves, fuel compression, cooling systems or fluids. Their so-called Wave Disk Generator could greatly improve the efficiency of gas-electric hybrid automobiles and potentially decrease auto emissions up to 90 percent when compared with conventional combustion engines. The engine has a rotor that's equipped with wave-like channels that trap and mix oxygen and fuel as the rotor spins. These central inlets are blocked off, building pressure within the chamber, causing a shock wave that ignites the compressed air and fuel to transmit energy. The Wave Disk Generator uses 60 percent of its fuel for propulsion; standard car engines use just 15 percent. As a result, the generator is 3.5 times more fuel efficient than typical combustion engines. Researchers estimate the new model could shave almost 1,000 pounds off a car's weight currently taken up by conventional engine systems. Last week, the prototype was presented to the energy division of the Advanced Research Projects Agency, which is backing the Michigan State University Engine Research Laboratory with $2.5 million in funding. Michigan State's team of engineers hope to have a car-sized 25-kilowatt version of the prototype ready by the end of the year.

Meet, share, collaborate and more with PGi iMeet. It is cloud-based system gives the user the ability to access live audio and video conferencing using desktop and mobile application. The standard iMeet live video meeting allows for up to 15 HD video feeds to run simultaneously, whereas an enterprise XL version will allow for up to 65 users at a time. Organizations can also customize the virtual conference room for branding. Can your online meeting solution offers all this? Try it out now.