LabVIEW Toolkit for LEGO MINDSTORMS NXT Program and control NXT devices with the full power of LabVIEW Get real-time updates from the NXT device during program operation with LabVIEW front panels Create native blocks for LEGO MINDSTORMS NXT software Figure 1.

anyrobot we do is basically going to be folllowing the wall though and it would have to go all the way to the end to start going back to the beginning

This is im pretty sure everything we have

That was a good idea declan thanks buddy

Tufts University Center for Engineering Education and Outreach In this activity, we will learn how to create a robot that follows a line on the ground. It will use one light sensor to sense where the line is, and use this to control the motors to steer the car and stay on the line.

All we would have to do is change those razor things out

Appendix B Direct Commands Reference Using Vernier Sensors with the NXT

its not exactly like ours similar

The following documents contain information that you might find helpful as you use the LabVIEW Datalogging and Supervisory Control (DSC) Module. You must install the PDFs to access them from this help file. You must have Adobe Reader 6.0.1 or later installed to view or search the PDF versions of these manuals.

Use front panel datalogging to record data for use in other VIs and in reports. For example, you can log data from a graph and use that data in another graph in a separate VI. Each time a VI runs, front panel datalogging saves the front panel data to a separate datalog file, which is in the format of delimited text.

sorta of a change in design than the last one i had thought was good

This is like a calculator you insert the gear it gives you the ratio

we just need to find that design