qmstech2

eothermal power plants do not burn fuel to generate electricity, so their emission levels are very low. They release less than 1% of the carbon dioxide emissions of a fossil fuel plant. Geothermal plants use scrubber systems to clean the air of hydrogen sulfide that is naturally found in the steam and hot water.

Geothermal plants emit 97% less acid rain-causing sulfur compounds than are emitted by fossil fuel plants. After the steam and water from a geothermal reservoir have been used, they are injected back into the Earth.

In 2011, U.S. geothermal power plants produced about 17 billion kilowatt-hours (kWh), or 0.4% of total U.S. electricity generation.

Most Geothermal Resources Are Near Plate Boundaries The most active geothermal resources are usually found along major plate boundaries where earthquakes and volcanoes are concentrated. Most of the geothermal activity in the world occurs in an area called the Ring of Fire. This area encircles the Pacific Ocean.

The ring of fire goes around the edges of the Pacific. The map shows that volcanic activity occurs around the Pacific rim.Source: National Energy Education Development Project (Public Domain) Naturally occurring large areas of hydrothermal resources are called

They may also reduce the amount of electricity generated from fossil fuels and therefore reduce the amount of air pollution, carbon dioxide emissions, and water use of fossil fuel power plants.

Modern wind turbines are very large machines, and some people do not like their visual impact on the landscape. A few wind turbines have caught on fire, and some have leaked lubricating fluids, though this is relatively rare. Some people do not like the sound that wind turbine blades make. Some types of wind turbines and wind projects cause bird and bat deaths. These deaths may contribute to declines in species that are also being affected by other human-related impacts. Many birds are killed from collisions with vehicles and buildings, by house cats and hunters, and by pesticides. Their natural habitats may be altered or destroyed by human development and by the changes in the climate that most scientists believe are caused by greenhouse gases emissions from human activities (which wind energy use can help reduce).

Making the metals and other materials in wind turbines and the concrete for their foundations requires the use of energy, which may be from fossil fuels.

.  To store hydrogen in liquid form, hydrogen must be cooled to -423 °F, requiring a tremendous amount of energy.

Hydrogen vehicle fueling stations may generate hydrogen on-site or receive deliveries of trucked-in hydrogen.

Hydrogen’s energy density is 52,000 Btu/lb., which is three times greater than that of gasoline.

Tidal turbines look like wind turbines. They are arrayed underwater in rows, as in some wind farms. The turbines function best where coastal currents run between 3.6 and 4.9 knots (4 and 5.5 mph). In currents of that speed, a 49.2-foot (15-meter) diameter tidal turbine can generate as much energy as a 197-foot (60-meter) diameter wind turbine. Ideal locations for tidal turbine farms are close to shore in water 65.5–98.5 feet (20–30 meters) deep

Geothermal energy has been used for thousands of years in some countries for cooking and heating. It is simply power derived from the Earth's internal heat.This thermal energy is contained in the rock and fluids beneath Earth's crust. It can be found from shallow ground to several miles below the surface, and even farther down to the extremely hot molten rock called magma.These underground reservoirs of steam and hot water can be tapped to generate electricity or to heat and cool buildings directly.A geothermal heat pump system can take advantage of the constant temperature of the upper ten feet (three meters) of the Earth's surface to heat a home in the winter, while extracting heat from the building and transferring it back to the relatively cooler ground in the summer

There are three types of geothermal power plants: dry steam, flash, and binary. Dry steam, the oldest geothermal technology, takes steam out of fractures in the ground and uses it to directly drive a turbine. Flash plants pull deep, high-pressure hot water into cooler, low-pressure water. The steam that results from this process is used to drive the turbine. In binary plants, the hot water is passed by a secondary fluid with a much lower boiling point than water. This causes the secondary fluid to turn to vapor, which then drives a turbine. Most geothermal power plants in the future will be binary plants.

It can be extracted without burning a fossil fuel such as coal, gas, or oil. Geothermal fields produce only about one-sixth of the carbon dioxide that a relatively clean natural-gas-fueled power plant produces.

Wind is created when the sun hits the earth. The air above water and the air above the ground heat at different rates. Since the air above the ground heats faster, the warm air from the ground hits the atmosphere first. It then is pushed out toward the sea. As the air heads toward the sea, it gets colder and sinks back down to the sea level. This creates a current pushing the sea air toward the land in the form of wind. The stronger the sun's energy on the land and water, the faster the wind will circulate.

As the gearbox turns, it feeds the RPM into the generator, which transfers the energy into usable electrical energy and stores it. Large cables are attached to the generator that feed the electrical currents from the generators of all the wind turbines on the farm into one electrical storage area. The energy can then be transported through power lines around the area for commercial and home usage.

Wave energy is produced when electricity generators are placed on the surface of the ocean

Energy output is determined by wave height, wave speed, wavelength, and water density.

The energy provided is most often used in desalination plants, power plants and water pumps.

Geothermal power has massive potential in many areas of the U.S. but it has long remained a niche technology.

The construction phase involves the construction of the geothermal field(s), infrastructure, power plants, and transmission lines.

Transmission lines, Electric power transmission or "high voltage electric transmission" is the bulk transfer of electrical energy, from generating Geothermal plants. Source(s): http://en.wikipedia.org/wiki/Electric_po… 2 years ago