Feel Safer in Your Bathroom by Installing Grab Bars to Your Shower Wall - 0 views
started by Kanstrup Lancaster on 11 Sep 13
started by Kanstrup Lancaster on 11 Sep 13
Start a New Topic » « Back to the What To Do After Graduating From High School: Consider Majorin group
You need to obtain the equipment needed seriously to set it up when a grab bar has been acquired by you. Listed here are the tools you will need:
Philips-head screwdriver
Punch
1/8 inch masonry bit or tile and glass bit
Stud person or perhaps a length of wire
Record measure
Silicon caulk
Sharp awl or carbide glass and tile routine bit
Wood bit, 1/16 narrower than the measurement of mounting screws
The very first thing that you will have to do to install your grab bar would be to find a wall stud. This may help greatly If you have access to a stud finder. Work the stud finder across the wall until a wall stud is located and mark the spot with an excellent point marker. Number concerns, just take a masonry bit or glass and tile bit and simply punch a hole in to the grout, should you not need an electronic stud finder. Then just take your amount of wire and produce a bend in it. Put the wire in the hole and by spinning it left and right you ought to hit a stud. The opening that you just drilled could be filled with a slight little bit of silicone caulk, if a stud was not located by you. Ensure that you trim the dab of silicone caulk therefore it does not protrude from the grout line, allow the caulk to dry for approximately three hours. If you have powdered grout convenient, mix up a little and patch the hole. Re-drill still another hole until a stud is located by you. I learned about dynamicdrillandblast by searching Yahoo. Measure 16 inches from that hole, when you do look for a stud and you should really be able to drill in to yet another stud.
You'll wish to mark your stud places in order that you can measure from the bottom of the container to determine the keeping of your bar. Position your bar so that each end has ended a stud and draw the screw holes that have been in the mounting bracket.
To drill the mounting holes in to tile you will need certainly to make a starting point for the drill bit if not the bit will stumble upon the tile. To create a starting place use a sharp awl or afore mentioned drill bit. Making use of your hand, twist the instrument on your make to make a slight impression on the tile; your drill bit will be kept by this from slipping. Do not make use of a strike or you are prone to split your tile. Dig up further about dynamicdrillandblast.com.au by visiting our refreshing article directory. Use your hole to be drilled by the glass and tile bit. Place tape over the tile, if utilizing a masonry bit and routine slowly in order to avoid breaking the tile. You dont desire to break your tiles when screwing the mounting brackets on both therefore make use of a bit that is 1/32 bigger compared to the size of the mounting screw you'll be using. Start drilling the hole gradually and with even pressure whilst to not slip off your mark. Use light pressure when going to avoid cracking the tile.
Make sure not to drill deeper compared to the tile and it assistance. Now, you will need to change your bit to the wood bit 1/16 narrower compared to the mess. This can make a pilot hole in the men.
The last step would be to attach the bar. Plastic caulk will have to be reproduced to the holes before mounting; this really is to safeguard the backing and wood boards behind the tiles from dripping water. Just screw the bar to the wall. You'll wish to use stainless screw or they will rust. Tighten the screws tightly making certain to not over tighten them or they'll crack the tile.
You should now have your grab club properly fitted. You can now take a peaceful, relaxing shower and feel safer in the process. Should you require to dig up further on dynamicdrillandblast.com.au, we recommend many resources you could pursue.