Washer Woes: Part 2 - How Exactly To Replace A Water-inlet Valve - 0 views
started by Meldgaard Thrane on 03 May 13
started by Meldgaard Thrane on 03 May 13
Start a New Topic » « Back to the Machine Woes: Part 2 - How To Replace A Water-inlet Valve group
This informative article follows on the very first article: Washer Woes: Part One Water Temperature. If youve currently read Part One and continue to be having problems managing your washer's water temperature, read onto learn how to analyze, test, and change your water intake valve.
The water atg electronics article inlet valve is entered by water through two tubes that are derived from the hot and cold water taps in your wall. Solenoids inside the water inlet valve react to the temperature selector switch and produce the selected water temperature. The water inlet valve is exited by the mixed hot and cold water via a typical line, answering your appliance with the right temperature of water.
Never try any repairs or maintenance in your washer without making certain the power to your washer is disconnected you could be seriously injured if the power isn't disconnected.
The water inlet valve is located at the back of your machine (in the case). Before examining the water inlet valve, check the water flow. Shut down the water taps (at the wall) and disconnect the tubes from the back of the washer. Area the disconnected end of every line in a empty container and switch on the water. Now always check the flow of water and to make sure the tubes are not blocked.
Remove and examine the water inlet valve, if the water flow led parking lot lights appears to be right. The device is held set up by two screws. Remove the screws and then disconnect the valves appliance complete hose by loosening the clamp that holds the hose in place on the valve.
Since the valve is removed, work with a small, flat-head screwdriver to pop out the valves intake screens. Vigilantly examine and clean any debris from the monitors. Be careful to not hurt the monitors - they can't be changed. If the monitors are led downlights without any debris, the next step would be to check the device.
To try the water intake valve, identify the wires attached with the devices on each solenoid. Label the wires just before removal to help you remember how exactly to reconcile them. The cables are secured in place by metal slip-on fittings. Use needle nose pliers to remove the connection from the final, when disconnecting the cables. Take the connector, perhaps not the wire. Replace the device, if the terminals and connectors are rusty or corroded.
Test your water intake valve for continuity, if the connections are fine. You certainly can do this with a multitester. Set your multitester to the ohms resistance level X1.
Each solenoid has two terminals. Test one solenoid at a time by using each of your meter's probes and pressing one to each terminal. Numbers can be different for every brand or model, but then the solenoid is broken and the valve must be replaced, if you get due to infinity.
To replace the old valve with a new one, connect the fill hose to the new valve and secure it in position with the screws. Attach the water hot and cold water hoses, and the wires to the solenoid terminals to the valve openings. Switch on the water, when every thing is secured. Check the water inlet valve and hoses for leaks before turning in your automatic washer and working it via a cycle.
Sometimes there is no method of knowing what is wrong along with your water inlet valve and replacing it may be the only real option. If you find this restoration hard to accomplish, or if you don't have an or a multimeter, contact a site technician.Discount Lighting Express, Inc
10940 Wilshire Blvd
Suite 1600, PMB #670
Los Angeles, CA 90024 USA
Phone: 800-899-8615