Experience Safer in Your Bathroom by Installing Grab Bars to Your Shower Wall - 0 views
started by Fitzgerald Robbins on 09 Jan 14
started by Fitzgerald Robbins on 09 Jan 14
Start a New Topic » « Back to the Congratulations! You are Marriage group
You need to obtain the equipment needed seriously to do the installation once a grab bar has been acquired by you. Cleaning Grout In Shower is a fresh resource for further about the inner workings of it. The following are the various tools you will need:
Philips-head screwdriver
Routine
1/8 inch masonry bit or glass and tile bit
Stud hunter or perhaps a amount of line
Record measure
Plastic caulk
Sharp awl or carbide glass and tile drill touch
Wood bit, 1/16 narrower compared to the size of mounting screws
The very first thing you will should do to put in your grab bar would be to locate a wall stud. This can help considerably when you have usage of a stud finder. Run the stud finder across the wall until a wall stud is situated and mark the spot with a fine point marker. If you do not have an electric stud finder, number problems, just take a masonry bit or glass and tile bit and only punch a hole in to the grout. Then simply take your amount of wire and produce a bend inside it. Put the cord in the hole and by rotating it left and right you should hit a stud. The opening that you just drilled could be filled with a small little bit of silicone caulk, if you do not locate a stud. Ensure that you flatten the dab of silicone caulk so that it doesn't protrude from the grout line, enable the caulk to dry for approximately three hours. Mix up somewhat and repair the hole, If you have powdered grout helpful. Re-drill another hole until you find a stud. When you do look for a stud, measure 16 inches from that hole and you should be able to drill into another stud.
In order that you can measure from the bottom of the tub to look for the keeping of your club you will wish to draw your stud places. Cleaning Grout In Shower includes more about the meaning behind it. Area your bar so that each end has ended a stud and draw the screw holes that come in the mounting bracket.
To drill the mounting holes into tile you'll have to produce a starting point for the drill bit otherwise the bit will find the tile. To make a kick off point use a sharp awl or afore stated drill bit. Using your hand, twist the tool on your make to make a small effect on the tile; this may keep your drill bit from slipping. Don't work with a impact or you're likely to crack your tile. Use the glass and tile bit to drill your hole. Place tape within the tile, if employing a masonry bit and punch gradually to prevent breaking the tile. You dont want to split your tiles when screwing the mounting brackets on both therefore work with a bit that is 1/32 bigger compared to measurement of the mounting screw you'll be using. Begin drilling the hole slowly and with even pressure whilst never to fall off your mark. Use light pressure when drilling in order to avoid cracking the tile. In the event people hate to get further on www, there are many online resources you might investigate.
Make sure to not drill deeper than the tile and it backing. Now, you'll have to modify your bit to the wood bit 1/16 narrower than the mess. A pilot hole will be made by this in the studs.
The final step would be to install the bar. Plastic caulk should be applied to the holes before mounting; that is to safeguard the support and wood boards behind the tiles from leaking water. Simply screw the bar to the wall. You will desire to use stainless screw or they will rust. Tighten the screws firmly making sure never to over tighten them or they'll crack the tile.
You ought to are in possession of your grab bar correctly installed. You can now have a calm, relaxing bath and feel safer along the way.